Part Number : LM9040
Function : Dual Lambda Sensor Interface Amplifier
Maker : Texas Instruments

Pinouts :
LM9040 datasheet

Description :

The LM9040 is a dual sensor interface circuit consisting of two independent sampled input
differential amplifiers designed for use with conventional Lambda Oxygen Sensors. The Lambda
Sensor is used for monitoring the oxygen concentration in the exhaust of gasoline engines
using catalytic after treatment and will deliver a voltage signal which is dependent on the air-fuel
mixture. The gain of the amplifiers are internally set and can directly convert the Lambda sensor output
voltage to a level suitable for A/D conversion in a system using a 5V reference.
The input common mode voltage range of each amplifier is ±2V with respect to the IC ground pin.
This will allow the IC to connect to sensors which are remotely grounded at the engine exhaust manifold or exhaust pipe.
Each amplifier is capable of independent default operation should either, or both, of the leads to a
sensor become open circuited.Noise filtering is provided by an internal switched capacitor low pass filter as part of each amplifier, and by external components.
The LM9040 is fully specified over the automotive temperature range of −40°C to +125°C and is
provided in a 14-pin Small Outline surface mount package.

2• Single 5V Supply Operation
• Common Mode Input Voltage Range of ±2V
• Differential Input Voltage Range of 50 mV to 950 mV
• Sampled Differential Input
• Switched Capacitor Low Pass Filter
• Internal Oscillator and VBB Generator
• Open Input Default Operation
• Cold Sensor Default Operation
• Low Power Consumption (42 mW max)
• Gain Set by Design Over the Operating Temperature Range

Datasheet PDF Download :
LM9040 pdf

Others datasheet of same file : LM9040,LM9040MX
2015/01/28 13:52 2015/01/28 13:52

This Blog provides Datasheets and information for electronic components and semiconductors